Getting Started
- Create a simple sketch using the Sketch Panel
- Dimension a sketch using the General Dimension command
- Extrude a sketch in the Part Features Panel using the Extrude command
- Create a fillet in the Part Features Panel using the Fillet command
- Create a hole in the Part Features Panel using the Extrude command
- Create a counter bore in the Part Features Panel using the Hole command
Learning More Basics
- Revolve a sketch in the Part Features Panel using the Revolve command
- Create a hole in the Part Features Panel using the Extrude command
- Create a series of holes in the Part Features Panel using the Circular Hole command
Learning to Detail Part Drawings
- Create an Orthographic view using the Drawing Views Panel
- Create a Solid Model using the Edit Views command
Advanced Detail Drawing Procedures
- Create an Auxiliary View using the Drawing Views Panel
- Create a Section View using the Drawing Views Panel
- Dimension views using the Drawing Annotation Panel
- Create Text using the Drawing Annotation Panel
Learning to Edit Existing Solid Models
- Edit the part using the Sketch Panel
- Edit the part using the Extrude command
- Edit the part using the Fillet command
Advanced Design Procedures
- Learn to use the X, Y, and Z
- Learn to use the Wireframe viewing
- Learn to project geometry to a new sketch
- Learn to use the Shell command
Introduction to Assembly View Procedures
- Learn to import existing solid models into the Assembly Panel
- Learn to constrain all parts in the Assembly Panel
- Learn to edit/modify parts while in the Assembly Panel
- Learn to assign colors to different parts in the Assembly Panel
- Learn to drive constraints to simulate motion
- Learn to create an .avi file while in the Assembly Panel
Introduction the Presentation Panel
- Learn to import existing solid models into the Presentation Panel
- Learn to design parts trails in the Presentation Panel
Introduction to Advanced Commands
- Learn to create a sweep using the Sweep command
- Learn to create a loft using the Loft command
- Learn to create a coil using the Coil command