Editor & Organizer Information | |
Magnesium Technology 2009 | |
Poster Session - Magnesium and Its Alloys | |
Effects of KCl on Electrical Conductivity of BaF2-LiF-MgF2 Electrolyte | |
Influence of Strontium Addition on Tensile Properties of Squeeze Cast AM60 Alloy | |
Tracing Nucleation and Grain Growth during Static Recrystallization of Pure Mg by EBSD | |
Age Hardening Response of Mg-Ce-Al Alloys | |
Effect of Grain Size on Corrosion Behavior of Squeeze Cast AJ62 Magnesium Alloy in Salt Solution and Automotive Coolant | |
Primary Production | |
Cathode Wetting Studies in Magnesium Electrolysis | |
Mechanism and Kinetics of Reduction of Magnesium Oxide with Carbon | |
A Study on Influence of Fluxing Additives on Magnesium Refining Process | |
Study on Ultrasonic Purification of Magnesium Alloy Melt | |
Prediction Model of Magnesium Powder Consumption during Hot Metal Pre-Desulfurization | |
Study on Electrolysis of Magnesium Oxide on 200A Scale | |
Vacuum Thermal Extract Magnesium from Boron Mud | |
Study on Behavior of Anode Bubble | |
Fatigue and Tension/Compression Asymmetry | |
Enhancing In-Plane Fatigue Resistance of Rolled AZ31 Magnesium Alloy by Pre-Straining | |
Influence of Stress Ratio on Fatigue Crack Propagation Behavior of AZ31 Alloy | |
Comparison of Quasistatic and Cyclic Plastic Behaviour of Wrought Magnesium Alloys | |
Casting | |
The Effect of Heat Treatment Conditions on the Mechanical Properties of Sand Cast Alloy MRI 202S | |
Melt Conditioned High Pressure Die Casting (MC-HPDC) of Mg-Alloys | |
Microsegregation Study of Mg Alloys and Adaptation of Directional Solidification Technique | |
Intermetallics Distribution in Two and Three Dimensions in High Pressure Die Cast Mg-Al Alloys | |
Investigations on Hot Tearing of Mg-Al Binary Alloys by Using a New Quantitative Method | |
Magnesium Recycling System Prepared by Permanent Mould- and High Pressure Die Casting | |
Solidification Behavior of Recyclable Mg Alloys - AZ91 and AZC1231 | |
Stresses and Cracking during Direct Chill Casting of AZ31 Alloy Billet | |
Refinement of Solidification Microstructures by the MCAST Process | |
Calcium | |
Creep Resistant Mg-Al-Zn-Ca-Sr Alloy | |
Effect of Ca on the Fluidity of AS41B Magnesium Alloy | |
Evolution of Grain Boundary Precipitate Depleted Zones in Mg-Ca-Zn Alloy Stabilized by Zr Additions | |
Flame Resistance Behaviors of AS, AE, MRI and AO Series Mg Alloys | |
Microsegregation and Creep in Mg-Al-Ca-Based Alloys | |
Thermodynamic Assessment and Its Application of Ternary Mg-Zn-Ca System Using CALPHAD Method | |
The Influence of Calcium and Cerium Mischmetal on the Ignition Behavior of Magnesium | |
Applications, Testing and Forming | |
A Life Cycle Assessment of a Magnesium Front-End Auto Part | |
Initial Evaluation of Advanced Powder Metallurgy Magnesium Alloys for Dynamic Applications | |
Microstructural and Mechanical Aspects of Reinforcement Welds for Lightweight Components Produced by Friction Hydro Pillar Processing | |
Die Forging of the Alloys AZ80 and ZK60 | |
Ignition-Proof of Magnesium Alloy and Preparation of Magnesium Foam | |
Applicability of Existing Magnesium Alloys as Biomedical Implant Materials | |
History of the Magnesium-Base Alloys Application in the Romanian Aeronautical Industry | |
Extrusion | |
Influence of Alloying Additions on the Microstructure Development of Extruded Mg-Mn Alloys | |
Texture Evolution in an AZ31 Mg alloy during Direct and Indirect Extrusion Processes | |
Influences of Load Direction and Grain Size on Tension-Compression Yield Asymmetry of Extruded AZ31 Magnesium Alloy | |
Rare Earth (Cerium and Other) | |
Microstructure and Mechanical Properties of an Mg-Rare Earth Based Alloy AM-SC1 | |
Interdependence between Cooling Rate, Microstructure and Porosity in Mg Alloy AE42 | |
Application of Neutron Diffraction in In-Situ Studies of Stress Evolution in High Temperature Creep Testing of Creep Resistant Magnesium Alloys | |
The Intergranular Microstructure of Magnesium Based Die-Cast AE Alloys | |
Rare Earth (Gadolinium, Neodymium) | |
Characterization of Dynamic Strain Ageing in Mg-3.11wt.%Gd Alloy | |
Effect of Cold Roll on Microstructure and Mechanical Properties of Mg-8Gd-3Y-0.5Zr Alloy | |
Effects of Heat Treatments on Tensile Properties and Creep Behavior of Mg-Y-Gd-Zr Alloys | |
The Fracture Behavior of the B2 Intermetallic, MgY | |
On the Microstructure and Texture Development of Magnesium Alloy ZEK100 During Rolling | |
Effects of Solid Solution Heat Treatment on the Microstructures and Mechanical Properties of Mg96.82Zn1Gd2Zr0.18 Alloy with 14H-Type LPSO Structure | |
Microstructure and Mechanical Properties of Hot Extruded Mg-3Nd-0.2Zn-0.4Zr | |
Refining and Surface Treatment | |
On the Influence of Settling of (ZrB2)P Inoculants on Grain Refinement of Mg-Alloys: Experiment and Calculation | |
Grain Refining of AZ91E Alloy Using Ultrasonic Vibration | |
The Influence of \946;-(Mg17Al12) Phase Distribution on Corrosion Behavior of AM50 Alloy in NaCl Solution | |
Study of Cathodic Metal Transfer to Magnesium Surfaces in Aqueous Environments and Engine Coolant Formulations by Surface Analytic Methods | |
New Surface Treatment for Developing Luster on AZ31 Magnesium Alloy in Industrial Scale | |
Characteristics of Phosphate Chemical Conversion-Coating on Magnesium Alloy | |
Electroless Ni-P Plating on Magnesium-Lithium Alloy | |
Twin Roll Casting and Semi-Solid Processing | |
NanoMag High Strength/Density Mg Alloy Sheet | |
Magnesium Alloy Strips Produced by a Melt Conditioned Twin Roll Casting (MC-TRC) Process | |
Microstructures of the Deforming Zone in Hot Rolling AZ31 Sheet | |
Effect of Warm Rolling and Heat Treatment on Microstructure and Mechanical Properties in Twin Roll Cast ZK60 Alloy Sheet | |
Development of Rolling Technology for Twin Roll Casted 1500mm Wide Magnesium AZ31 Alloy | |
Development of 150cm Wide Wrought Magnesium Alloys by Twin Roll Strip Casting Technique in Turkey | |
Wrought Alloys | |
Age Hardening Response and Microstructures of ZK60 Alloy with Li Additions | |
High Temperature Deformation Behavior of Three Rolled Sheets of Magnesium Alloy AZ31 | |
Physical Metallurgy of Mg AZ80 Alloys for Forging Applications | |
Effects of Alloying Elements on Texture and Mechanical Properties of Extruded Mg-Zn-Al Alloys | |
Formability of Magnesium Sheet | |
Application of Incremental Forming Technique to Mg-AZ31 Sheet | |
Grain Size Effect on Hot Forging of Mg Alloys | |
Deformation Mechanisms in AZ31 Magnesium Alloy Tube Bending | |
Yttrium and Tin | |
Microstructure and Mechanical Properties of Mg-Al-Mn and Mg-Al-Sn Alloys | |
Directionally Controlled Precipitation on Twin-Boundaries in Mg-Zn-Y Alloys | |
Effect of Extrusion Temperature on the Microstructure and Mechanical Properties of Mg97Y2Zn1 Alloy | |
Effect of Trace Elements on Age Hardening Behavior of Mg-Sn Alloy | |
Effects of Sb Additions on the Microstructure and Mechanical Properties of As-Cast Mg-5%Sn Alloy | |
Thermodynamic Modeling and Its Applications to Mg-Sn Based Alloy Development | |
Strengthening Mechanisms in Mg-Al-Sn Based Alloys | |
Relation between the Microstructure and the Plastic Deformation Behavior in Mg12ZnY with the LPSO Structure | |
Effect of Rare Earth Elements Addition and T6 Heat Treatment on Creep Properties of Mg-Al-Zn Alloy | |
Modeling and Deformation | |
Blind Study of the Effect of Processing History on the Constitutive Behavior of Alloy AZ31B | |
Deformation Mechanisms in Magnesium Alloy Elektron 675 | |
Effect of Precipitates on Deformation Mechanisms at Low-Temperature in an AZ80 Magnesium Alloy | |
Elevated Temperature and Varied Load Response of AS41 at Bolted Joint | |
High Temperature Deformations and Microstructural Evolutions of Mg Alloy Laminated Composites Fabricated by ECAE | |
New Microalloyed Magnesium with Exceptional Mechanical Performance | |
Study on Rolling Process of Mg-9Li-2Zn Alloy Plate | |
A New Approach for Inverse Parameter Calculations of the Plastic Deformation Behavior of AZ31 Magnesium Alloy | |
Microstructural Investigation of Twins under the Fracture Surface in AZ31 Mg Alloys | |
Test Results and FEA Predictions from Magnesium AM30 Extruded Beams in Bending and Axial Compression | |
Author Index | |
Subject Index | |
Table of Contents provided by Publisher. All Rights Reserved. |
The New copy of this book will include any supplemental materials advertised. Please check the title of the book to determine if it should include any access cards, study guides, lab manuals, CDs, etc.
The Used, Rental and eBook copies of this book are not guaranteed to include any supplemental materials. Typically, only the book itself is included. This is true even if the title states it includes any access cards, study guides, lab manuals, CDs, etc.